Owners manual vulcan 500

As a result, the percentage of E10 petrol is lower than that of E5 petrol, making it less bad for the environment. How often should I replace the oil filter on my Kawasaki engine? An oil filter must be replaced every kilometres approx. How often should I change the oil of my Kawasaki engine? The oil must be changed every kilometres approx. This page was last updated: Remove as many rubber or plastic parts from the carburetor as possible before cleaning the carbure- tor with a vu,can solution.

Be sure that all parts are put back in the correct sequence and facing the proper direction, and that all circlips and washers are properly in place. There are several forums that provide a wealth of information on this subject. Also, check to see that each cotter pin is in place and in good condition. If the battery is charged while still in- stalled, battery electrolyte may spill and corrode the frame or other parts of the motorcycle.

The clearance may exceed the standard slightly, but it must not be less than the min- imum in order to avoid bearing seizure. Reserve Tank Cap 8. If the fan turns, inspect the fan switch. Special tools, gauges, and Indicates a procedural step or work to be testers that are necessary when servicing done.

Apply silicone sealant [A] around the circumference of the wiring grommets before setting them in the notch in the alternator cover. Right Hand Switch Lead Apply silicone sealant [A] around manula circumference of the wiring grommets before setting them in the notch in the alternator cover.

Disc Runout Not more than 0. If it does not, adjust the rear brake cam lever angle. Ignition Fuse 10A J. Coolant Filter Housing Set the coolant filter housing parallel to the outer side of the frame.

Note the follow- ing. This valve seat cutter is developed to grind the valve for repair. This will burn out the diodes in the electrical parts. Connecting Rod Twist — — — 0. Run the hoses inside the 2. Ownfrs Blue main harness. Run the hose below the 8. Number of bids and bid amounts manuql be slightly out of date. Ignition Switch Lead 3. If the coolant is brown, iron or steel parts are rusting. We will make every attempt possible to resolve the issue if we made a mistake. This will burn out the diodes in the electrical parts.

If a megger or a meter with a large-capacity battery is used, the IC igniter will be damaged. If not, manial piston must be replaced. The headlight comes on after the starter button is released and stays on until the ignition switch is turned off. Engine Amnual Switch 7.